Energenie EGM-PWML Manual de usuario descargar pdf (Pagina 7)

EGM

PWM

LAN ENERGY METER WIT

H LAN INTERFACE

All brands and logos are registered trademarks of their respective owners

NOTE: by default the factory setting of EGM-PWM-LAN is DHCP

enabled. If your LAN has a router with built-in DHCP server (which is

very common) then EGM-PWM-LAN will automatically get an IP address

from the DHCP server. Proceed to section 3.2 below in this case.

NOTE: you may prefer to connect EGM-PWM-LAN directly to the

managing computer LAN adapter (network card) using the supplied

crossover RJ-45 cable (option B). You might need to use this option if

your LAN does not have DHCP server.

If you choose for option B then the following procedure is required to let

EGM-PWM-LAN obtain a fixed IP address:

• Power EGM-PWM-LAN on

• Press Reset button on the side control panel (see Figure #2 above)

with the tip of a pen

• Holding it pressed for about 3 seconds

The above-mentioned procedure forces EGM-PWM-LAN to reset

itself to the default settings (see below) ...

• IP: 192.168.0.254

• Subnet mask: 255.255.255.0

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Sin comentarios

Energenie EGM-PWML Manual de usuario Pagina 7